5150 Auto Sport - ARP Head Stud Kit BMW S58 Engines Head Stud Kit 5150 Auto Sport royalty-bespoke.myshopify.com

5150 Auto Sport - ARP Head Stud Kit BMW S58 Engines

SKU: ARP-HSK-S58-S
Availability: On request

Sale
Regular price EXCL VAT: 4 287 kr

INCL VAT (21%): 5 187 kr

Choose

Quantity

Stand out with this incredible 5150 Auto Sport ARP Head Stud Kit for your BMW S58 Engines. (Years: 2019 - Present)

Upgrade the performance of your BMW S58B30T0 engine with our ARP Head Stud Kits. Specifically designed for the turbocharged inline 6-cylinder S58 engines found in high-performance models such as X3M F97, X4M F98, M3 G80, M4 G82, and M4 G83.

As you increase the power output of your engine beyond its factory specifications, the head and block may start to separate, causing factory bolts to stretch and fail. Our ARP Head Studs are designed to be stronger than factory bolts, ensuring your race engine stays together even under extreme conditions.

Our Custom Age 625+ kit is made from a material with a tensile strength of 260 ksi, substantially higher than the 190 ksi of the ARP 2000 head stud. It's an ideal choice for individuals who want to push the limits of their S58 builds.

Installation Instructions:

1. To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block. Chase if necessary with ARP Thread Chaser.

2. Clean and inspect all hardware prior to installation. Look for obvious defects or shipping damages, plus proper fit, length and dimension.

3. If the cylinder head studs protrude into a water jacket, lubricate the block threads of the studs with ARP THREAD SEALER.

4. Screw studs into the block “HAND TIGHT ONLY”.

5. Install the cylinder head(s) and check for binding or misalignment.

6. Lubricate the stud threads, nuts and washers with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT.

Then install the washers and the nuts onto the studs and tighten them hand tight.

ARP recommends using the ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT that is provided with each kit as opposed to motor oil. This is due to higher friction on the studs as well as inconsistencies in the clamping force of the fasteners when motor oil or other low quality lubricants are used.

PRELOAD (TORQUE) RECOMMENDATIONS

7. Following the manufacturers recommended torque sequence tighten the nuts steps 1-3

ARP2000

Step 1: Tighten to 30 ft-lbs.

Step 2: Tighten to 60 ft-lbs.

Step 3: Tighten to 90 ft-lbs.

Custom Age 625+

Step 1: Tighten to 30 ft-lbs.

Step 2: Tighten to 60 ft-lbs.

Step 3: Tighten to 100 ft-lbs.

with ARP Ultra-Torque fastener assembly lubricant

Bolt Torque Sequence

12	10	4	2	6	8	14
13	7	5	1	3	9	11

Please note: After initial assembly, it is necessary to allow the engine to complete a full heat cycle, then re-torque your head studs to spec. This means allowing the engine to warm up to its normal operating temperature, remain at operating temperature for several minutes to ensure each component is uniformly heated, then turned off and cooled completely to ambient temperature.

Images of products are only for information purposes and can change due to continuous product development. Prices, images and product description are subject to change without notice. Not responsible for typographical errors.